Showing 1–12 of 14 results
This adjustable aluminum support rod is designed for use on splitters, spoilers, and any other use. Our unique design allows for maximum strength, lightness, and durability while delivering a highly aesthetic appearance. The ends are reverse-threaded to allow for adjustability without removing the part, and mounting hardware is included.
Our support rods are machined from 6061-T6 aircraft grade aluminum, using high quality, fine threaded rod ends allowing for full adjustability.
Rod length end to end is 7 inches. Can be adjusted to 12 inches.
Weight: 1 lb
This Camaro 6th Gen front splitter extension is made from a composite light weight Poly Metal 6mm material. Color is a satin black finish on all sides. This kits is designed to fit the 2016-18 models with the SS front splitter.
The Camaro rear diffuser is made from 6mm composite light weight Poly Metal material. Color is a satin black finish on all sides. These kits are designed to fit the Camaro SS and 1LE dual mode exhaust rear bumper. Total weight of this diffuser is less than 10lbs.
These rear Side Skirts are made of 6mm composite light weight poly metal material. They are satin black on both sides and will easily mount to your rear diffuser.
These rock guards are designed to extend out protection against rocks. Don’t buy the cheap plastic guards that everyone else has, get the 3 mm composite light weight poly metal guards that are a show room quality finish that will blow people away at shows.
These side skirts are made of 6mm composite light weight poly metal material. They are satin black on both sides , these mount flush on to your bottom plastics.
This is a 1 PIECE Wicker Bill made of 3mm cutting edge composite Poly Metal material with a black satin finish.